ICS 680GC Recoil complete 71415

STARTER HOUSING ASSEMBLY • To reattach the starter housing, first pull the starter cord out, then hold the starter housing against the crankcase. Slowly release the starter cord to enable the pulley to fit between the pawls. • Insert and tighten the screws. Use blue Loctite® #242. TENSIONING THE RECOIL SPRING Lift the starter cord up into the notch on the starter pulley and wind the pulley clockwise 5 full turns. Remove the cord from the pulley notch while pinching the pulley. Release the pulley slowly allowing it to wind the rope counterclockwise onto the pulley. • When completed, the starter handle should be pulled back in the starter housing under it’s own tension. • To check that the starter pulley was assembled correctly, pull the cord completely out of the housing, grip the pulley and turn clockwise another 1/2 turn. If the pulley turns another 1/2 turn it is correctly assembled. STARTER CORD REPLACEMENT • Remove the 4 screws that attach the starter assembly to the crankcase. • Pull the cord out approximately 8 in and lift the cord up into the notch in the pulley. Relax the recoil spring by placing thumb on pulley and gently allow the pulley to unwind entirely. Undo the screw in the center of the pulley and remove the pulley. • Thread the new cord through the starter cover and fasten it to the pulley. Wind 4 turns of the starter cord on to the pulley. Assemble the starter pulley against the recoil spring so the end of the spring engages into the backside of the pulley. Install the retaining screw in the center of the pulley.