Norton Clipper CE414-350SS 14" Blade 4.2HP Hand Held High Speed Cut-off Electric Saw 70184694536
Operating Information
10
REV 06/23.
When Starting
Only use the power tool if it is in completely assembled condition.
Hold the tool securely and firmly when starting.
Always start up on level ground and securely hold the power tool.
Perform the starting process as described in chap. 6 on page 24.
Electrical Safety
Keep at least 9.8 feet (3 meters) distance from any flammable material when operating this
machine.
Plug the power tool into the appropriate matching grounded outlet with the matching voltage
(115v/60Hz/1). Do not attempt to adapt the plug head to use with a non-matching outlet.
Avoid contact with earthed or grounded surfaces to avoid electric shock.
Keep the power tool away from water. Do no leave the machine outside where it may be rained
upon. Water exposure will increase the risk of electric shock.
Do not pressure wash or wash the machine. Water exposure will increase the risk of electric shock.
Do not carry the tool by the power cord. Do not use the machine if the cord is damaged. A
damaged cord will increase the risk of electric shock. If damaged have the cord repaired by a
certified technician immediately.
Use extension cables with the correct length and gauge. Refer to section 4.1 and view the
recommended extension cable chart if not known what type of extension cable to use.
Keep extension cables unrolled during use to maintain the power tool’s efficiency.
Only use undamaged extension cables to reduce the risk of electric shock.
When operating the power tool, make sure the power cable is always behind you.
Do not use the power tool if the power trigger does not turn on the motor. A malfunctioning power
switch should be repaired by a certified technician.
During Work
In addition to the safety provisions already listed, the following safety provisions also apply
when working with the motor device:
Secure the workplace against accidental access by third parties, ex. with warning signs.
Only persons involved and wearing adequate protective equipment and clothes must be
SAFETY
PRECAUTIONS
11
REV 06/23.
present within 30 meters [approx. 30 yards] around the working area.
Check the site of deployment for possible dangers.
Spark formation during cutting means that work must never be performed close to
potentially explosive due to shortages.
No electrical lines, water or gas pipes or flammable substances must be placed in the
area to be cut.
Objects that may fall off or topple over during work must be secured or removed from
the working environment first.
Prepare the workplace so that secure operator mobility is possible.
The work piece to be cut must be free of foreign bodies such as screws, nails or stones.
When working in residential areas, observe the noise protection provisions.
Work carefully, considerately, and calmly and do not endanger others.
Ensure good sight and light conditions.
Always remain within calling distance of other persons who may administer first aid in
emergencies.
Schedule work breaks.
Be attentive towards possible danger sources and take the corresponding preventive
measures. Consider that use of hearing protection limits perception of sounds. Signal
sounds, calls, etc. thatannounce danger may also be missed.
Observe tripping dangers and obstacles. Never work on unstable grounds.
Always hold the power tool with both hands and always ensure a safe and firm stance.
Never cut standing on a ladder.
Guide the power tool so that no body part is located in the extended swivel range of
the cut-off wheel.
Do not hold the work piece in your hand and bring it into contact with the wheel.
Bring the rotating cut-off wheel into contact to the work piece.
Never touch the floor or other objects with the cut-off wheel running.
Do not use the power tool to level off and shovel away objects.
Switch off the motor when the power tool starts to behave noticeably differently |